Current location:Home>>Products>>PCD Wire Drawing Die Blanks >>TDW series (Tungsten carbide supported die blanks)

  TDW Series - It is drawing block supported by hard alloy ring, polycrystalline diamond and hard alloy ring bond tightly. It is supporting ring that enhances the strength of block. This series can bear high strength drawing.

Specification of TDW series

  According to the drawing application, for each series we have different grain sizes of 1?m, 3?m, 5?m, 10?m, 25?m, 50?m for customer’s choice.

ADDMA*
Desination
Production Code Dimension(mm) Grain Size(μm) Diagram
Total Blank Diameter
ΦD
Diamond Diameter
Φd
Diamond Thickness
T
Maximum Recomm-ended Hole Size
1 3 5 12 25 50
D12 TDW1515 3.99 1.4 1.5 0.8
D15 TDW4023 8.12 3.8 2.3 1.8
D18 TDW4029 8.12 3.8 2.9 2.3
D21 TDW7040 13.65 6.8 4.0 3.5
D24 TDW7053 13.65 6.8 5.3 4.6
TDW13070 24.13 13.0 6.98 5.2
D27  TDW13087 24.13 13.0 8.7 5.8
D30 TDW130116 24.13 13.0 11.6 7.6
D31 TDW150120 24.13 15.0 12.0 8.0
D33 TDW150150 26.80 15.0 15.0 11

* ADDMA: American Diamond Die Manufacturers’ Association

Note: 1. Die blanks must be cased below 650℃;
   2. Maximum recommended die size for soft nonferrous wire Haid wire diameter normally should not    exceed 65% of this diameter;
   3.● Stock item ○ Order item ﹣Not available

Order Code of TDW series

  Product Code+“-”+Avg. Grain Size+“/”+?ADDMA Designation,For example:“TDW1515-005/D12”。

Site Map | About Us | Legal Notices | Mail | Contact Us

Copyright ? na-superhard.com, All Rights Reserved. Design By info@na-superhard.com

Back to Top